Dürkopp Adler M-TYPE H867, Service Manual

Page: 35 / 92

Setting the feed-dog
Service manual H867 Version 00.0 - 08/2013 33
9.1.2 Moving the feed-dog carrier
For the basic setting, the feed-dog carrier has to be moved both sideways
and in the sewing direction.
The feed-dog carrier is connected to the stitch regulator gear via the slid-
ing shaft and can be moved on this shaft.
Cover
• Tilt the upper section backwards
(

Section 4.4.1 Access to the machine bottom section , page 10)
Figure 23: Moving the feed-dog carrier
Setting steps
1. Position the upper stitch length adjusting wheel to 0.
2. Loosen the connection to the tie rod using the screws (1).
3. Loosen the rear assembly frame screw (6).
4. Loosen the setscrews for the adjusting rings (2).
5. Move the feed-dog carrier cross-line to the sewing direction such that
the feed-dog is exactly in the center of the throat plate cut-out.
6. Push the adjusting rings (2) toward each other as far as they will go.
Important: Make sure that the sliding shaft (3) is tightened by the
clamping rings.
7. Tighten the setscrews for the adjusting rings (2).
8. Move the feed-dog carrier in the sewing direction such that the feed-
dog is exactly in the center of the throat plate cut-out.
9. Tighten the rear assembly frame screw (6).
10.Tighten the connection to the tie rod using the screws (1).
Important: In the process, make sure that the feed-dog height has the
correct setting (

Section 9.2.2 Setting the feed-dog
height in the top dead center , page 38).
1
2
4
3
4
6
5
5
(1) - Tie rod connecting screws
(2) - Adjusting rings
(3) - Sliding shaft (4) - Assembly frame
(5) - Plates
(6) - Assembly frame screw