Duplo DC-516, Instruction Manual

Page: 98 / 142

80
Process
3URFHVV&UHDVH
6(7
&UHDVH
)HHG
&UHDVH'HSWK
0,'
0,1
6WDQGDUG
0$;
3URFHVV&87
6(7
&87
)HHG
&XW7ULP
0RGH
7UDLO&XW0RGH
)XOO%OHHG0RGH
6WDQGDUG
$XWR
Lead margin, trail margin and gutters (48.9 mm
or shorter) are chopped up and dropped into the
waste box. Select
Full Bleed Mode , No Bleed
Mode , or Process All with the arrow (left/right)
icons.
If the document has no lead margin or trail
margin, select
No Bleed Mode .
3URFHVV&UHDVH
6(7
&UHDVH )HHG
&UHDVH'HSWK
0,' 0,1
6WDQGDUG
0$;
Touch the module name in slot 1 , the module name
in slot 2 , or Feed to switch displays.
The module name in slot1/2 of the JOB selected are
displayed.
If
no data is programmed in the JOB selected, you
cannot enter Process .
Touch each button to make settings.
Touching the
return icon returns to the standby
screen without saving the settings.
Touching
SET saves the settings and the standby
screen reappears.
● When the standard module is installed in slot 1
The setting screen for slot 2 are displayed because there are no settings for the standard
module .
(The fi gure on the right shows when the creaser module is installed in slot 2 .)
● When the creaser module is installed in slot 2
Select a crease depth from MAX , MID , or MIN .
● When the cutter module is installed in slot 2 .
1. Cut Trim Mode
Full Bleed Mode : Lead margin and trail margin are chopped up and dropped into the
waste box.
No Bleed Mode : This chops up the gutters of shorter than 49 mm and drops into the
waste box.
Process All : All of the cut pieces are ejected to the exit tray .
Gutters shorter than 42 mm are chopped up and dropped into the waste
box.
Trail margin shorter than 67 mm are chopped up and dropped into the
waste box.
Feed
Module
in Slot2
Module
in Slot1