Duplo DC-516, Instruction Manual

Page: 105 / 142

87
2
System
Basic Operations
3
6\VWHPࠉࠉ([LW
%DWFK6HSDUDWLRQ
)HHG
2))
6(7
([LW 2WKHUV
21 2))
(QG0DUN
6\VWHPࠉࠉ([LW
%DWFK6HSDUDWLRQ
*DS7LPLQJ
(QG0DUN
)HHG
$XWRPDWLF
6(7
([LW 2WKHUV
VHF
ڸ
ڸ
21 2))
6\VWHPࠉࠉ([LW
%DWFK6HSDUDWLRQ
)HHG
2))
6(7
([LW 2WKHUV
21 2))
(QG0DUN
6\VWHPࠉࠉࠉ)HHG
'%/'HWHFWLRQ
)HHGHU&DSDFLW\
)HHG
2)) 21
6(7
([LW 2WKHUV
0$; 0,1 0,'
2. Feeder Capacity
The elevator level can be adjusted to the three
levels below according to the document quantity.
Select
MAX , MID , or MIN .
Normally select MID .
MAX : Select this when loading high quantity of
documents
MIN : Select this when loading low quantity of
documents
System − Exit
1. Batch Separation
This sets a time interval between the last process
of a document and the next one.
OFF : This starts processing documents without a time
interval.
Automatic : This starts processing the next document
after the time set in Gap Timing elapsed.
Manual : When the set number of documents are
processed, the machine enters document-
feed standby mode.
REFERENCE
Pressing and holding the CLEAR key resets the value to the default ( 5 seconds).
2. Gap Timing
This is active when Automatic is selected in Batch
Separation . This sets a time interval between the
last process of a document and the next one.
Touch the
arrow (left/right) icons to adjust value of
Gap Timing .
You can adjust value in the range of 1 to 30
seconds.
End Mark
This is active when Automatic or Manual is
selected in Batch Separation in step 4.
When you use a document with end mark printed
on the last edge of it and touch ON , the JOB
fi nishes processing a document with end mark
printed on it.
ON : Select this when you use this function.
OFF : Select this when you do not use this function.
REFERENCE
When Batch Separation is set to OFF , the end mark setting is not displayed.
When End Mark is set to ON , you cannot set the number of sheets of documents.
Pressing the START key restarts feeding documents.
When 30 minutes have elapsed without pressing the START key, the machine
stops operation.