Duplo DC-516, Instruction Manual

Page: 47 / 142

2
29
Slitter Modules
Before Using This Machine
1
When making gutter slit width 5 mm, 10 mm, or 15
mm, set the
slitter unit (right) to the left of the position
where gutter slits are to be made and the slitter unit
(left) to the right.
Use the gauge vertically as shown in the fi gure on the
right.
Adjust the
pins of the slitter units (left/right) to either
hole (5 mm/10 mm/15 mm) of the gauge .
If you cannot adjust the position of the slitter unit (left)
because the
gauge comes into contact with it, set the
gauge in the opposite orientation.
In order to adjust the next slitter unit position, have the
U-shaped part of the gauge come into contact with the
pin of the slitter unit secured in step 4 with no gap.
(The right fi gure shows the slitter unit (left) and the
slitter unit (right) .)
When using three or more slitter units , adjust the
positions of the slitter units with the gauge in the same
way as step 7.
Slitter unit (right) Slitter unit (left)
Change the orientation of the gauge