Duplo DC-516, Instruction Manual

Page: 103 / 142

85
2
Adjust
Basic Operations
3
<(6 12
$GMXVW
-2%
6DYH6KULQNDJH$GMXVW$OO
/DVWFXWYDOXHV
LQWKLV-2%IRUIXWXUH"
$GMXVWࠉࠉࠉ$GMXVW$OO
6HOHFW-2%
/HQJWK
VW
ੈ
ੈ
/DVW
ੈ
ੈ
$SSO\6KULQNDJH
6(7
$GMXVW
Adjust − Adjust All
The values of the following items of the JOB selected
are displayed as reference values.
Length
1st CUT/1st crease
Last CUT/Last crease
Touch the arrow (left/right) icons to adjust values.
Every time the arrow (left/right) icon is touched, a
value increases/decreases by 0.1.
Touching the
arrow (down) icon after adjusting a
value displays the Adjust − Last Cut Adj. screen.
Touching SET displays the Adjust screen in step 9.
$GMXVWࠉࠉࠉ/DVW&XW$GM
ੈ
$SSO\6KULQNDJH
$GMXVW
6(7
Ѝ
The Adjust screen as shown in the fi gure on the right
appears.
To save the settings, touch
YES . If not, touch NO .
After the settings are saved, the standby screen
reappears .
Cut
Crease
Reference value
(Current position)
Adjust − Last Cut Adj.
This compensates the last cut position.
Touch the
arrow (left/right) icons to adjust value.
You can make adjustment in the range of -0.5 to +0.5
mm.
+ direction: This moves the last cut position toward
the lead edge of the document.
- direction: This moves the last cut position toward the
trail edge of the document.
REFERENCE
The arrow (down) icon is displayed only when the cutter module is installed in slot 2 .
REFERENCE
Last Cut Adj. is displayed only when the cutter module is installed in slot 2 .