Duplo DC-516, Instruction Manual

Page: 117 / 142

2
99
When Messages Appear
4
Troubleshooting
Message Status and Solution
J08 - *EXIT TRAY
Remove document from exit tray
Status: A document jam in the document exit area.
Solution: Remove the jammed document from the
document exit area.
J09 - *WASTE BOX AREA
Remove waste from waste box
Status: A document jam in the waste box area.
Solution: Remove the jammed document from the
waste box area.
SLOT1 UPPER LOCK
Check document in Slot1 area
Status: The upper tool in slot 1 is locked.
Solution: Remove the jammed document from slot 1
and press the STOP key.
Turn OFF the power and then turn ON again
after a few seconds. If the same message
remains displayed, take a note of it and
contact our service person.
SLOT2 UPPER LOCK
Check document in Slot2 area
Status: The upper tool in slot 2 is locked.
Solution: Remove the jammed document from slot 2
and press the STOP key.
Turn OFF the power and then turn ON again
after a few seconds. If the same message
remains displayed, take a note of it and
contact our service person.
RTM LOCK
Check document in Slot1 area
Status: The RTM (optional) is locked.
Solution: Remove the jammed document from slot 1
and press the STOP key.
Turn OFF the power and then turn ON again
after a few seconds. If the same message
remains displayed, take a note of it and
contact our service person.
EMERGENCY STOP
Release Emergency SW
Status: Emergency stop.
Solution: Release the emergency stop switch.
REG READ ERROR 2
Cannot read REG Mark
Status: REG mark reading error.
Solution: Press the STOP key to clear the error.
Check if REG mark is printed properly.
REG READ ERROR 4
Check REG position
Status: REG mark reading error because of it not
printed properly.
Solution: Press the STOP key and check if REG mark is
printed as speci fi ed in the speci fi cations and if
the document is not skewed.
END MARK READ ERROR 1
Cannot read End mark
Status: END mark reading error.
Solution: Press the STOP key to clear the error.
Check if END mark is printed properly.