Duplo DC-516, Instruction Manual

Page: 138 / 142

120
Index
A
About Protection of Sponge Rollers ..... 114
Adjust ...................................................39,83
Adjust all ...................................................38
Adjust All ..............................................83,85
Adjusting the Air Amount ........................12
Adjusting the Elevator Height .................12
Adjusting the Height of the Separator ....12
Adjusting the Suction Skew ....................14
Air
fl ow adjustment knob ............................2
Air knife .....................................................48
Air Knife ...........................................57,79,81
Apply shrinkage ........................................38
Apply Shrinkage ..................................83,84
Attaching the Card Stacker (Option) ......16
Attaching the Guide .................................30
Attaching the Guide (Ejection Side) .......16
Attaching the Slitter Units .......................25
B
Back guide ..........................................2,3,10
Batch separation ......................................38
Batch Separation .................................86,87
Bearing holder .....................................22,24
Buzzer ........................................................89
C
Category Name .........................................91
Change Directions of the Creaser Tools
(Upper/Lower) ..................................32
Changing the Stored JOB ........................68
Chute guide ...............................................21
Cleaning mode ..........................................38
Cleaning the Feed Rollers ..................... 113
CLEAR key ..................................................8
Control panel ..............................................2
Control Panel ..............................................8
Copy function ...........................................44
Count .........................................................38
Counter ......................................................38
Crease ...................................................56,62
Crease Depth ............................................79
Crease depth 1, 2 ......................................49
Crease position .........................................48
Creaser concave tool ...............................31
Creaser convex tool .................................31
Creaser module ...................................43,50
Creaser Module .........................................31
Creaser tool (lower) ....................................4
Creaser tool (upper) ...................................4
Cut position ...............................................48
Cut Slit .......................................................62
Cutter module ......................................43,50
Cutter Module .............................................6
Cutter speed ..............................................49
Cutter Speed .............................................83
Cut trim mode ......................................48,59
Cut Trim Mode .................................57,79,80
D
Daily Maintenance .................................. 112
DBL Detection ...........................................86
Detail ..........................................................38
Dial ............................................................21
Driving shaft ..............................................24
E
Elevator down switch .................................2
Emergency stop switch .............................2
End Mark .........................................36,86,87
Enter JOB Screen .....................................43
Environment .........................................39,89
Exit tray .......................................................3
F
Feeder Capacity ...................................86,87
Feed guide ..............................................4,10
Feed guide adjustment knob ................2,10
Feeding support tray ..................................2
Feed tray ......................................................2