edit.
3. The first time you press the EDIT Key, the mode indicator in the cen-
ter of the bottom row of the display will show E
C
(Edit Clock Mode)
and the text area will show a 12 or 24 hour time. See Section 25.3.2
for setting the clock for 12 or 24 hour operation.
4. Use the L & R Throttle knobs to dial up the “current” time. Use the L
Throttle for hours and the R Throttle for minutes. You can only
move time forward. Press the EDIT Key
again to set the time
and move on to edit the fast clock rate.
5. When you press the EDIT Key the second time, the mode indicator
will display E
F
(Edit Fast Rate) and the text will show Rate=nnn
where nnn is the clock rate. Use the throttle knobs to dial up a clock
rate that is between 000 & 120 (the throttle will let you dial up to
255 in this case but values above 120 have no meaning to the sys-
tem). Press the EDIT Key
again to set the fast clock rate and
move on to edit the throttle alarm time.
6. Once the time and fast clock rate are set, the mode indicator will dis-
play E
A
(Edit Alarm) and the text will show a 12 or 24 hour time.
Use the throttle knobs to dial up the alarm time. Press the EDIT Key
again to set the fast clock alarm. NOTE: The fast clock alarm
can’t be turned off.
7. Once the time, fast clock rate and alarm are set, you will automatically
return to Fn Mode unless your system is enabled for other types of
editing such as routes. If you are set up for routes, the clock editing
screens will be followed by Er for editing routes as described below.
To exit Edit mode at any time simply press the EXIT Key
.
20.0 FIND Key & Digitrax Transponding
On layouts set up for Digitrax transponding with transponders in locos and
rolling stock and transponder receivers installed on the layout, the DT400’s
FIND Key is used to turn on the find command. This lets you see the zone
location of transponders on the layout in your throttle display.
To use the FIND Command:
1. The layout must have Digitrax transponder receivers (BDL16 &
RX4s) installed and configured.
2. The loco or other rolling stock that you want to track must have a
transponder installed. This can be either a transponding decoder or a
stand alone transponder.
E X I T
E D I T
E D I T
E D I T
83