locomotives are set up to move in the same direction and are not
pulling against each other.)
5. Press the MU Key
, the display will show the following:
the MU mode indicator on the
LCD display is lit. The loco
address in the L side of the
display will blink to show that
it is the address that will be
consisted to the address on the
R Throttle.
6. The DT400 display will prompt you to press the Y + Key
to
add the loco address or the N - Key
to remove the loco address
from the consist controlled by the TOP loco address selected on the
R Throttle. You will see the LCD alternate between the following
two screens to remind you of which key to press.
7. Press the Y + Key
to add the left address to the consist.
The L Throttle display shows the address of the loco that was added to
the consist with a cn in the text line above it. The R Throttle display
shows the address of the TOP loco address and its current % of full
speed. The R Throttle is now in control of the speed & direction of
both locomotives in the consist.
You can access the functions of the any loco in the consist by selecting the con-
sisted loco to a throttle and using the function keystrokes outlined in Section
12.2. You will not be able to change the speed or direction of any loco that is
part of a consist but, is not the TOP loco, while it is consisted.
Once a consist is set up & linked to the TOP locomotive, this TOP loco can be
released & selected to run from either throttle on your DT400. The consist can
also be selected and run on another throttle or it can be dispatched to another
throttle.
Y
+
N
Y
+
M U
63