at a time can have access to the keypad and function controls. The active throt-
tle has access to the function controls and the status of the functions for the
active throttle are displayed in the top line of the LCD. To make either throttle
the active throttle simply click it once or turn the Throttle knob a little.
No Loco Icon = nothing selected on this side of the throttle
Loco with steady smoke = Keypad and function display not active
for locomotive address selected on this throttle.
Loco with flashing smoke = Keypad and function display active for
the locomotive address selected on this throttle.
6.3.4 Mode Indicator
The mode indicator, located at the bottom center of the LCD, shows the
DT400’s current mode of operations.
TABLE III: DT400 Mode Indicator Display
Display Mode
Used For
Lo
Loco
Normal locomotive operation
Fn
Function
Function mode for toggling functions
on or off.
Mu
MU
Multiple unit (consist) operation set
up and break up
Sw
Switch
Accessory decoder control (turnouts,
etc.)
S
E
Status Edit
Change locomotive speed steps to 14,
28, or 128 as needed
Pg
Programming Paged-Digitrax preferred method
Ph
Programming Physical Register
Pd
Programming Direct
Po
Programming Operations Mode (Ops Mode)
programming on the mainline.
R
E
Recall
Recall one of the last 4, 8, or 16
locomotive addresses used
Ec
Edit Clock
Edit the time shown on the fast clock
E
F
Edit Clock
Rate
Edit the fast clock rate
E
A
Edit Alarm
Edit the alarm time set for the throttle
42
