Any DT series throttle (including your DT400) that is plugged in to your
LocoNet system will update its fast clock time and rate to be synchronized to
the rest of the system a couple of seconds after it is connected to LocoNet.
Each DT400 can be set up with an alarm. When the current fast clock time
matches the private alarm time set in any DT400, then that DT400 will beep
and flash the message “Alarm” to indicate that the alarm time has elapsed.
The fast clock rate for the fast clock is user selectable from 1:1 to 100:1 in
steps of 1. The most popular range of values are 4:1 to 8:1.
19.2 Stop the Fast Clock
Setting the clock rate to 00 will stop the fast clock for the entire system
at the currently displayed time. Fast time will re-start when a new
non-zero rate value is set.
The current fast clock time, fast clock rate and the DT400 alarm time can be
changed by using the Edit mode.
19.3 Edit Fast Clock Time, Rate & Alarm
To Edit Fast Clock Time, Rate & Alarm
Note: DT400 must be plugged in to LocoNet to edit the fast clock settings.
1. From Fn mode, press the EDIT Key
to change to Edit Mode
mode.
2. Press the EDIT Key
to scroll through the different things you can
E D I T
E D I T
Display with FastClock showing 12:00am
1. Address 6104 running at 25% speed on
the Left throttle in the reverse direction.
2. Address 25 running at 75% speed on
the Right throttle in the forward direction.
Blinking smoke shows that Address 25
is currently active in the display so its
active functions, 0 & 3 are displayed on
the top line of the LCD.
82
