Digital PRIORIS XL Server
Digital PRIORIS XL Server
Troubleshooting
Troubleshooting
76
76
MCS Logistics Engineering - Nijmegen
MCS Logistics Engineering - Nijmegen
P
R
I
O
R
I
S
X
L
Server Troubleshooting
(continued)
Problem
Possible Cause
Action
Server operates
incorrectly after
installing
optional system
memory
(SIMMs)
SIMMs have failed.
Replace SIMMs.
Server does not
boot from an
IDE hard disk
drive
Operating system soft-ware is
not installed on the IDE hard
disk drive.
IDE hard disk drive is not
correctly formatted or requested
partition does not exist.
There is no software on the
requested partition.
IDE hard disk drive jumpers
incorrectly set.
IDE drive type incorrect.
Loose cables.
Onboard IDE interface disabled.
"Boot from Hard Disk C" is
disabled in SCU.
Install the appropriate operating system.
Format the IDE hard disk drive or partition the
IDE hard disk drive using the supplied operating
system software.
Install software on the requested partition.
Refer to the supplied IDE hard disk drive kit
installation instructions.
Run the SCU to identify the correct drive type.
See drive type label on drive or consult drive
documentation.
Secure all cable connections.
Run the SCU and set the IDE Hard Disk Drives
option to "Enabled".
Run the SCU and enable the "Boot from Hard
Disk C" option.
Server does not
recognize an
internal SCSI
device
SCSI device jumpers incorrectly
set.
SCSI ID conflicts.
Terminating resistors not
removed from the SCSI device.
SCSI controller has failed.
Main logic board jumper
incorrectly set.
Refer to the supplied kit installation instructions.
Refer to the supplied kit installation instructions.
Remove terminating resistors. Refer to the
supplied kit installation instructions.
Replace SCSI controller.
Make sure jumper J22 (Enable Wide SCSI) is
properly set for the Internal wide SCSI devices
installed.
