Utilities & Configuration
Utilities & Configuration
Digital PRIORIS XL Server
Digital PRIORIS XL Server
18
18
MCS Logistics Engineering - Nijmegen
MCS Logistics Engineering - Nijmegen
P
R
I
O
R
I
S
X
L
To access SETUP.EXE:
1) Insert the CD-ROM startup diskette into drive A.
2) Boot the server.
3) Allow the POST to complete.
If POST detects a configuration error(s),
refer to Chapter 4, “Troubleshooting”
for possible causes
and suggested solutions.
4) Highlight
Modify BIOS setup
from the main menu, and then press
[Enter].
Page 1 of Setup appears.
5) Press the right arrow key to move the cursor to the ROM Based Setup option. Change the setting to
Enable/Disable.
6) Follow the instructions on the screen to exit SETUP.EXE (saving the changes).
7) Remove the CD-ROM startup diskette.
8) Reboot the server.
EPP3SMC.EXE
EPP3SMC.EXE can be executed as an MS-DOS command or added to the CONFIG.SYS file as a device
driver. In either case, use the BIOS Setup utility or the SCU to set the parallel port to EPP Mode.
Configuring The Server
This chapter provides detailed information on how to configure the server using the System Configuration
Utility (SCU). Digital recommends that you use the SCU to initially configure the server and each time
you add hardware, remove hardware, or change server settings.
If the server was delivered with factory-installed hardware and software, the server has already been
configured.
