Digital PRIORIS HX MP Server
Digital PRIORIS HX MP Server
Troubleshooting
Troubleshooting
MCS Logistics Engineering - Nijmegen
MCS Logistics Engineering - Nijmegen
67
67
P
R
I
O
R
I
S
H
X
M
P
Chapter 4
Troubleshooting
The following pages provide initial troubleshooting procedures and tables listing specific problems,
probable causes, and recommended actions to take if the computer fails after configuration or after
installation of optional hardware or software.
Refer to the documentation supplied with additional options when experiencing problems with specific
options that you have installed.
Initial Troubleshooting
Follow these general procedures to troubleshoot the PRIORIS HX MP Server:
♦
Press [Ctrl] + [Alt] + [Del]. If the computer fails to boot, turn it off, wait until all hard disk drives are
spun down completely, and then turn it back on.
♦
If the POST detects an error refer to
chapter 4
“
Troubleshooting”
and take the appropriate steps to
correct the problem. After the problem has been resolved, restart the computer.
♦
Run the BIOS Setup utility.
♦
Make sure all necessary changes have been made to the CONFIG.SYS and AUTOEXEC.BAT files
♦
Make sure all necessary video, printer, and application device drivers are properly installed.
♦
Ensure that all cables and connections are secure.
♦
Run the
QAPLUS/fe
advanced diagnostic software.
♦
If these steps do not identify and/or correct the problem, perform the specific troubleshooting
procedures appropriate to the circumstances.
NOTE
If you need to return a failed component, pack it in its original container and return it to
Digital for service.
Fill in the appropriate fields of the Part Exchange Form with the relevant error information!!
