Digital PRIORIS HX
Digital PRIORIS HX MP Server
MP Server
Server Utilities & Configuration
Server Utilities & Configuration
MCS Logistics Engineering - Nijmegen
MCS Logistics Engineering - Nijmegen
21
21
P
R
I
O
R
I
S
H
X
M
P
NOTE
At any time you can view IRQ, DMA, and memory assignments while in the SCU by
selecting [F7], the “View Additional System Information” menu. From this menu, select
either Used Resources or Available Resources.
When a PCI video expansion board has been installed, the server will automatically
disable the onboard video controller and use the installed PCI video expansion board.
Make sure to switch the video signal cable from the onboard video connector to the
connector on the PCI video expansion board.
Relocating Expansion Boards
Perform the following steps
before
relocating an ISA expansion board and
after
relocating an EISA or PCI
expansion board:
1) Insert the backup System Configuration Utility diskette into drive A and then soft boot (reset) the
server.
2) Press
[Enter]
to display the SCU main menu and then [
Enter]
again to continue.
3) From the
Configure The Computer
menu, select "Step 2: Adding and Removing Boards”.
4) Highlight the expansion board to be relocated, press
[Enter],
and then follow the instructions
displayed on the monitor screen.
5) Select "Step 5: Save and Exit," to save the configuration and exit the SCU.
If there are no resource conflicts, the new configuration information is saved to the .SCI file. If there is a
conflict, resolve it before completion of the server’s configuration.
Deleting Expansion Boards
Perform the following steps
before
deleting an ISA expansion board and
after
deleting an EISA or PCI
expansion board.
NOTE
Also remove the deleted expansion board’s .CFG file from the SCU.
1) Insert the backup System Configuration Utility diskette into drive A and then soft boot (reset) the
server.
2) Press [
Enter]
to display the SCU main menu and then
[Enter]
again to continue.
3) From the
Configure The Computer
menu, select "Step 2: Adding and Removing Boards”.
4) Highlight the expansion board to be deleted, press
[Enter],
and then follow the instructions displayed
on the monitor screen.
5) Select "Step 5: Save and Exit," to save the configuration and exit the SCU.
If there are no resource conflicts, the new configuration information is saved to the .SCI file. If there is a
conflict, resolve it before completion of the server’s configuration.
