Table 3–1 (Cont.):
Initial Key Functions
Key
Key Function in
OFF LINE Mode
Key Function
in
ON LINE Mode
(9)
FCT
Enters Function Selection state (refer to function
procedures: Printer Initialization, Forms Setup,
and Margin Setup). This key is also used to
achieve Reverse Form Feed as follows: Press key
(9) to enter Function Mode, then press key (6) for
Reverse Form Feed (paper moves back one form
length). Also used by service personnel in aligning
printer.
No operation.
Function Mode Summary
State
Key
INITIALIZATION
FORM SETUP
PRINT REVIEW
FORMS ADJUST
MARGIN SETUP
REVERSE FORM FEED
BUFFER CLEAR
Press (1)
Press (2)
Press (3)
Press (4)
Press (5)
Press (6)
Press (7)
Refer to Chapter 4 for the above function mode
procedures.
3.6 Paper Tension Lever
The paper tension lever adjusts the pressure that the paper tensioning
fingers apply to the paper (see Figure 3–10). There is a PAPER THICK-
NESS scale, from 1 to 6, located next to the paper tension lever. The
higher the number (the heavier the paper), the less the tension. A ‘‘1’’ is
equivalent to 15-pound one-part paper. Adjust for the maximum tension
without smearing the print.
3–16
CONTROLS AND INDICATORS
