Table 7–2 (Cont.):
Possible Electrical Problems and Remedies
Observed Problem
Probable Cause and Remedies
5.
This display will be produced by the ribbon
weld detector sensing a damaged ribbon or
defective ribbon weld detector.
[ 0 2 0]
[ 4 2 0]
Occasionally, usually after transporting, the printer
can lock up with one or both of these codes. Press
the reset twice to clear and then perform the power
up reset sequence detailed in Table 4.4, followed by
the initialization procedure in Table 4.3. If the fault
recurs after power off, the error codes are valid as
in Table 5.2.
7.3 Printer Parameters
The factory settings for the printer are listed in Table 7–3.
NOTE
The following tables refer to ‘‘Control Functions’’, which are
listed in the LG31 Printer User’s Guide EK-LG31E-UG.
OPERATOR MAINTENANCE
7–5
