Solving Problems
5.4 Running Self-Tests
If the self-test is successful, no question mark or error message is
displayed, and the console prompt appears:
7...
>>>
If a device fails the self-test, a failure message is displayed before the
console prompt appears.
7?..
84 FAIL
>>>
If a self-test results in a failure, run the configuration display to show any
error codes.
5.5 Displaying System Configuration Information
The InfoServer 150 system can display configuration, Ethernet ID, ROM
revision levels, and status information. Error information displayed is valuable
to your service representative. Have this information ready if you must
call for service. See Chapter 3 and Appendix A for additional information.
Table 5–3 lists the mnemonic code used for each device. To display your system
configuration, perform the following steps:
1.
Put the system in console mode by pressing the halt button on the rear of
the system unit and then pressing Return.
2.
Enter the TEST 50 command at the console prompt. The following example
shows a typical display. Table 5–3 lists the mnemonic code used for each
device.
>>> TEST 50
Return
KA41-2
V1.0
ID 08-00-2B-03-79-1F
CLK
0000.0001
NVR
0000.0001
DZ
0000.0001
00000001 00000001 00000001 00000001 00000000 00000000
MEM
0004.0001
00400000
MM
0000.0001
FP
0000.0001
IT
0000.0001
SCSI-A
1C1C.0001
V1.3
FFFFFF05 00000001 05000001 FFFFFF05 FFFFFF05 FFFFFF05 FFFFFF03 FFFFFF05
5–8
