Expanding Your System
3.1 Guidelines for Connecting Expansion Boxes
is self-sensing, so the system unit does not need a voltage selection
switch.
•
Turn on all expansion boxes before you turn on your system unit. This step
ensures that the device in each expansion box is ready for use, and that
the system firmware includes the device in its configuration.
3.2 Preparing Your System for an Expansion Box
If you plan to add an expansion box to your system, you must first remove the
SCSI cover and the terminator connected to the SCSI port.
1.
Place your fingers under the SCSI cover’s locking tab and lift off the SCSI
cover. Then remove the SCSI terminator as shown in Figure 3–1.
Figure 3–1 Removing SCSI Terminator
S C S I T e r m i n a t o r
M K V - X 3 1 3 0 - 9 1
Save the terminator and cover — you must reattach them if you disconnect all
expansion boxes from the system unit.
3–2
