OPERATOR’S MANUAL
IntelliAg MVT
11001-1643A-201411
ACCESSORY SENSORS / 89
PRESSURE FILTER
Filters the signal out of the pressure sensor. Typically no filtering is required
and therefore the standard value is set at 0%. If the pressure readout on the
Main Work screen is oscillating in excess of 10%, increasing the filter value
filters the signal to reduce the oscillation. For a true pressure value this
number should be set to 0%.
RPM SENSOR SETUP
If an RPM sensor is installed, the number of RPM sensors installed is
manually entered on the Accessory Sensor screen in the # of RPM column.
IMPORTANT: Performing an Auto Config does not detect installed
RPM sensors.
The RPM Setup button only displays on the Accessory screen when a
value is entered.
To Setup RPM Sensors:
1. At the Accessories screen, press the RPM Setup button.
2. Highlight the yellow input box and push in the rotary dial to open
keypad and set the desired values.
3. Press the OK button and push in rotary dial to accept.
– Press the Next RPM button to set parameters for additional sensor.
Figure 71
RPM Setup Screen
MT - PCM
MT - PCM
Nitro Software, Inc.
100 Portable Document Lane
Wonderland
Page 94
