OPERATOR’S MANUAL
IntelliAg MVT
11001-1643A-201411
SECTION CONTROL -MANUAL / 97
SECTION CONTROL -MANUAL
Section Control is available for manual shutoff of sections as previously
planted areas are approached.
Controlling sections by rows require:
•
Planter output modules (1 to 4 depending on how many sections)
•
Row shutoff modules (1 to 4 maximum)
The following screens must be configured to perform Manual Section
Control functions:
•
Control channel setup assigning number of rows per channel
•
Clutch module assignment
•
Switch assignment
Clutch configuration is required to:
•
Identify how many planter output modules are connected to the
IntelliAg system
•
Assign how many outputs are assigned to each output module
•
Assign how many rows are assigned to each output
•
Assign row shutoff module switches to outputs that enable and disable
planter sections
# OF OUTPUTS TO MODULES
Multiple Tru Count Output Module Assignment
Output module addresses are a critical parameter to identify a module’s
position on the implement that controls row shutoff switches.
IMPORTANT: If a planter uses more than one output module, modules
MUST be installed in increasing serial number order
starting on the left side and proceeding to the right so
that row assignment is configured correctly.
To Enter # of Outputs per Module:
1. At the Top Menu screen, press the Module Config button.
2. At the Module Config screen, press the Clutch Module button.
3. At the Clutch Configuration screen, enter the number of solenoid
outputs for each module. Outputs do NOT always total the number of
clutches but the total number of controlled solenoids. The Output
Numbers (#s) value is automatically sequenced for each module
based on the module address value.
Nitro Software, Inc.
100 Portable Document Lane
Wonderland
Page 102
