OPERATOR’S MANUAL
IntelliAg MVT
11001-1643A-201411
ACCESSORY SENSORS / 87
ACCESSORY SENSORS
The Accessory Sensor screen displays the optional sensors installed, such
as an RPM to monitor shaft/fan or an air pressure sensor. The system
detects attached pressure and hopper sensors during an Auto
Configuration typically done during module setup. RPM sensors must be
configured manually and are not recognized during an Auto Configuration.
Specific setup parameters for installed sensors must be defined at the
respective setup screen (Pressure Setup, Hopper Setup, and RPM Setup).
PRESSURE/RPM ASSIGNMENT
The Pressure/RPM column displays the total number of RPM or pressure
sensors that are connected to each module. When a pressure or RPM
sensor is entered into this column, the proper sensor numbering sequence
for each module is automatically entered into the MAP column based upon
the module address value.
To Manually Assign Pressure or RPM Sensors:
1. Press the Accessory button.
2. Highlight either the Pressure or RPM yellow input box to enter the
number of sensors assigned to the module.
3. Push in the rotary knob to accept.
TIP: Press the Top Menu/Auto Config button to auto populate pressure
sensors and hopper sensors.
Figure 69
Accessory Assignment Screen
MT - PCM
MT - PCM
Nitro Software, Inc.
100 Portable Document Lane
Wonderland
Page 92
