44
EN
16652807_en 05 /2006
The net wrapping system does not require any
maintenance.
Check the parallelism of anvil (1) and cutting bar (2)
to ensure that the net is cut correctly. To adjust proceed
as follows:
z
Cutting bar must be released (in contact with the
anvil)
z
Undo the securing bolts (3) of the anvil;
z
Release the lock nuts and use setting screws (4)
until the anvil is parallel to the cutting bar.
z
Be sure there is no gap between anvil and cutting
bar and tighten the lock nuts and the securing bolts
(3).
The cutting bar can be reversed three times. The hoop
with the beating arm can be tensioned manually (see
illustration). To do so, place suitable round material in
the bore of the bearing shaft and turn until it engages
firmly.
5.5
Tailgate
Warning !
Take care when opening and closing the
tailgate. Shut the hydraulic shut-off tap
before entering the bale chamber. No
persons may remain in the swinging
range of the gate.
The tailgate is activated directly from the double-acting
control unit. The tailgate is opened fully using the ‘Raise’
function on the control unit. The tailgate is closed with
‘Lower’ on the control unit. If the tailgate is open the
control box screen displays „OPEN“.
If the tailgate is completely closed the control box screen
displays „RUN“ (The P.T.O. shaft must be switched on).
1
4
3
2
Summary of Contents for MP135 R
