DEUTZ-FAHR MP135 R, Operation Manual

Page: 30 / 62

28
EN
16652807_en 05 /2006
5 Operation
5.1 "Autoform" operation and control unit
Caution!
Always protect the control box from moisture and mechanical damage. Supply voltage
required is 12V.
Descr Descr
Descr Descr
Descrip ip
ip ip
iption of push butt tion of push butt
tion of push butt tion of push butt
tion of push buttons: ons:
ons: ons:
ons:
(1) Preselection cutter in/out; after preselection, the upper LED lights up; the lower LED lights up
when the blades are swivelled in
(2) Selects „switching the cutting mechanism on and off“; LED lights up when function is selected
(Position 1 and 2 cannot be activated together)
(3) Adjusting twine clearance to edge of bale
(4) Selects „net wrapping“; LED lights up when function is selected
(5) Selects „twine wrapping“; LED lights up when function is selected
(6) Switches from automatic to manual wrapping initiation; LED lights up when manual mode is
selected
(7) Clear button; clears the day counter, clears error indications if problem has been eliminated
(8) Activates the day counter for 3 seconds; pressing this button again will activate the total counter
for 3 seconds
(9) Program button for the number of net or twine wraps and for the automatic cutting knife
engagement; Twine edge clearance; volume control for peep signal
(10) „Autoform“ switch, 0= off, I= on, II= emergency mode, see below
(11) Toggle switch - emergency control of net or twine wrapping system; overrides the electronic
control
(12) Cable with screw connection
(13) LED - lights up when the blades are swivelled in
A
1 5 4 3 6 2
7
8
9 11
2
PROG PROG PROG *)
*) RESET = POWER OFF-ON + PROG + C
PROG
AUTO
13