DEUTZ-FAHR MP135 R, Operation Manual

Page: 24 / 62

22
EN
16652807_en 05 /2006
4 Installation and
adjustments
Warning !
Adjusting, maintenance and repair work
is only to be carried out when the motor
is switched off and the machine is at a
standstill. Remove ignition key.
4.1 Tractor equipment necessary
The necessary PTO shaft speed to operate the round
baler is 540 rpm.
The PTO shaft must guarantee operation independent
of the tractor coupling.
To control the hydraulic functions, the round baler
requires:
z a single-acting control unit (one remote connection)
z a double-acting control unit (two remote
connections)
Warning !
First connect the hydraulic line with the
yellow marking. Then place the control
unit to “lower” (close the tailgate) and
check the pressure on the pressure gauge.
Then and only then connect the hydraulic
line with the red marking.
A three-pin socket that meets the DIN 9680
specifications must be provided on the tractor for current
supply to the "Autoform". The current supply for lighting
is drawn from a seven-pin plug.
When using the optionally available pneumatic/
hydraulic 40 km/h brake axles, the appropriate tractor
connections are necessary.
4.2. Mounting the "Autoform"
To mount the "Autoform", the clamp clip (a) is mounted
in a clearly visible position on the safety frame/roll bar
or on the centre bar of the tractor cab. The mount (b) is
screwed to the clamp clip and forms the receptacle for
the "Autoform".