DEUTZ-FAHR MP135 R, Operation Manual

Page: 15 / 62

13
EN
16652807_en 05/2006
8. Operating devices (ropes, chains and linkage) of remote controlled equipment must be installed in
such a way that they can not trigger unintentional movements in any transport and working position.
9. Couple equipment according to regulations, and attach and secure to the prescribed devices.
Particular care should be taken when coupling and decoupling equipment to or from the tractor.
10.When attaching or detaching, bring the support devices into the position necessary. Be conscious
of its stability.
11.Never run the engine in an enclosed area.
12.Check the surrounding area (children) before driving away and starting up. Ensure that you have
adequate visibility.
13.Passengers may not be carried on the equipment while on a transport journey. No work may be
carried out on the device while in operation.
14.Always adjust travelling speed to suit weather and terrain conditions. Avoid taking sudden curves
on inclines and declines and transverse travel on an incline.
15.Attached equipment influences road performance as well as steering and braking. Ensure that you
can steer and brake adequately.
16.When taking curves, bear in mind the overhang width and the centrifugal mass of the device.
17.Only operate the device if all protective equipment is in place and in protection position.
18.It is forbidden to remain in the working and danger area.
19.Do not remain in the rotating and swinging range of the device.
20.There are crushing and cutting areas at power-driven parts (e.g. hydraulic parts).
21.Secure equipment before leaving the tractor. Lower the attached implement fully. Switch off the
engine and remove the ignition key.
22.No one may remain in the area between the tractor and device if the vehicle is not secured against
rolling away by a wheel chock.
23.Note the permissible axle load and total weight as well as the permissible transport dimensions.
1.8.2 Attached devices
1. Secure the device so that it cannot roll away. The wheel blocks are located behin the hinged door
on the right hand side of the machine.
2. Take note of the maximum permissible support load of the drawbar coupling, the pending attachment
or hitch.
3. Ensure that the drawbar trailer has sufficient mobility at the point of attachment.