DEUTZ-FAHR MP135 R, Operation Manual

Page: 54 / 62

52
EN
16652807_en 05 /2006
7 Accessories
7.1 Cutting system
The round baler is prepared for fitting the ‘Opticut’
cutting system as standard. When delivered without
cutting system, components such as the conveying drum
and cutting-unit floor are included in the basic machine
supply schedule.
The assembly component ‘Opticut cutting system’ for
retrofitting includes a blade unit with mechanical
components and hydraulic and electrical controls.
7.2 Filler plates
When the cutting device is not mounted or if the cutting
system is being used with less than 14 blades, the slits
in the floor of the cutting unit are to be closed using
filler plates. The filler plates keep the blade slits clean
and ensure that the flow of material around the floor of
the cutting unit remains even. The filler plates are stored
on the machine and are located on the left-hand side
wall of the baler underneath the protective plates.
Dismantled blades can also be placed on this mount.
7.3 Bale ramp
When using the bale ramp, the bales are deposited
gently onto the ground and roll out of the tailgate area
so that, under normal working conditions, it is not
necessary to drive forward again to close the tailgate.
Caution !
Only open the tailgate when the machine
is running to make sure that the bale is
ejected.
Warning !
On sloping ground, the bales should be
deposited face down on the slope. There
is a risk of injury if the bales roll away.