DEUTZ-FAHR MP135 R, Operation Manual

Page: 43 / 62

41
EN
16652807_en 05/2006
5.4.2 Twine binding
If the round baler is fitted with a twin-threaded twine binding mechanism, the crop can be bound into
bales which are stable in shape with a preselected number of crosswise twine bindings.
The twine binding process is activated, the number of twine wraps (14 - 28) and the option for automatic
or manual binding start-up are carried out using the "Autoform", see Section 5.1.
The twine container is located in front of the binding mechanism and holds 6 rolls of twine. An additional
twine box is available for holding 6 extra rolls of twine (right-hand side of the machine). When equipped
for net wrapping, the net roll container can also be used to hold 4 twine rolls.
Warning !
When inserting new twine rolls and when threading the twine, switch off the tractor engine
and wait for the machine to come to a standstill. Remove the ignition key.
Thr Thr
Thr Thr
Threading twine: eading twine:
eading twine: eading twine:
eading twine:
z Guide the ends of the threads from the yarn rolls out of the yarn container(s) through the
breakthroughs shown in the illustration
z
Guide the ends of the threads through the yarn brakes (caution: different spring tension for one or
two threads)
z
Guide each thread through a thread tightener and porcelain eyelet
z
Place each thread with a loop of approx. 360° anti-clockwise over one plastic guide roller
z
Guide through the porcelain eyelet on the frame (front or back)
z Guide the thread through the upper bundle eyelets, between the rollers, guide springs and then
through the lower bundle eyelets (slightly turning the rollers for thread feed)
z Thread length at the exit point: 50 mm
Caution !
Never reach into the zone of the yam knife! Risk of injury!
B ca. 3-4mm
A ca. 7-8mm
A/B
11-12mm
50m
m
50m
m