DEUTZ-FAHR MP135 R, Operation Manual

Page: 36 / 62

34
EN
16652807_en 05 /2006
Binding wit Binding wit Binding wit Binding wit Binding with t h t h t h t h the ne he ne he ne he ne he nettttt:::::
z
Move the switch on the machine box (right hand
side of the machine) from zero setting to the net
setting (at the top).
z
Move the rocker switch (11) to the left to activate
net intake.
z
After the net has started, release the rocker switch
(check through the slots).
z After approx. 4 seconds, move the rocker switch
to the right until the net is cut off (net roller at a
standstill!)
z
Then move the rocker switch to the left for approx.
1 second (zero setting).
z After the binding procedure is finished, move the
switch on the machine box back to its zero setting.
Binding wit Binding wit Binding wit Binding wit Binding with twine: h twine: h twine: h twine: h twine:
z Move the switch on the machine box (right hand
side of the machine) from zero setting to the yarn
setting (at the bottom).
z Move the rocker switch (11) to the right for approx.
15 s to activate the yarn slide.
z Move the rocker switch to the left to cut off the
twine + further 3 s; check through the yarn disk on
the top of the machine.
z After the binding procedure is finished, move the
switch on the machine box back to its zero setting.
5.2 Pick-up
The pick-up is set as described in Section 4.6. During
use, the pick-up is to be positioned at the preset height
above the feeler wheels on the ground, and the control
unit set to floating position. Optimal and careful crop
pick-up is ensured by following the lie of the ground.
When turning and when picking up extremely large
volumes of crop the travelling speed is to be adjusted
according.
Warning !
Only change the shear bolts on the pick-
up when the engine is switched off and the
machine is at a standstill. Remove the
ignition key.
A
11
PROG PROG PROG *)
*) RESET = POWER OFF-ON + PROG + C
PROG
AUTO