DEUTZ-FAHR MP135 R, Operation Manual

Page: 34 / 62

32
EN
16652807_en 05 /2006
A A A A Adjus djus djus djus djusting t ting t ting t ting t ting the signal v he signal v he signal v he signal v he signal volume olume olume olume olume
z
Press programme button (9)
z
Press the bale counter button (8) several times
to adjust the volume
z Press the programme button (9) to save the setting.
RRRRRese ese
ese ese esettttt: binding twineand ne
: binding twineand ne
: binding twineand ne : binding twineand ne : binding twineand net.t.t.t.t.
There is a reset function in the case of defects in the
binding procedure for checking the zero setting or
recalibration:
z Select the net binding button (4) or twine binding
button (5)
z Press the programme button (9) together with the
delete button C (7) (confirmation given by 2 x
peep signal)
z The selected binding system is then checked
Reset: complete electronic system Reset: complete electronic system Reset: complete electronic system Reset: complete electronic system Reset: complete electronic system
Checking the complete electronic system
z Switch the control unit “Autoform” off and on again
(switch 10)
z Press the programme button (9) together with the
delete button C (7) (confirmation given by 2 x peep
signal)
z
Calibration of the extension length of the mains
motor; where applicable, the zero setting of the
yarn slide is re-adjusted; the internal electronic
components are checked (individual settings are
retained!)
A
8 9
PROG PROG PROG *)
*) RESET = POWER OFF-ON + PROG + C
PROG
AUTO
A
5 4 7
9
PROG PROG PROG *)
*) RESET = POWER OFF-ON + PROG + C
PROG
AUTO
A
7
9
PROG PROG PROG *)
*) RESET = POWER OFF-ON + PROG + C
PROG
AUTO