DEUTZ-FAHR MP135 R, Operation Manual

Page: 45 / 62

43
EN
16652807_en 05/2006
Installing the net roll, inserting the net: Installing the net roll, inserting the net: Installing the net roll, inserting the net: Installing the net roll, inserting the net: Installing the net roll, inserting the net:
z
After removing the spring plug, pull out the net roller
holder (right-hand side), unlock by turning the
handle briefly to the right,
z
Insert the roll of net, pushing the cardboard tube
onto the rubber section on the left-hand roll holder,
z
Slide the right-hand net roller holder into the
cardboard tube, lock and secure with spring plug,
z Align the net roll to the middle of the bale chamber,
z Turn the hand wheel (2) sharply - the roll of net
is fixed axially by spreading the rubber section,
z Unroll the netting from the roll, place over the guide
tube and then around the netting tensioning
clip(1),
z Place the net over the guide tube (4) and the plastic
net spreader (5),
z Spread the start of the net folded in half and insert
between the rubber roller (6) and the aluminium
roller (7), turn the rubber roller (6) with an Allen
key on the mount (left- hand side) until the net is
securely gripped,
Chec Chec
Chec Chec Checking t
king t
king t king t king the disk br
he disk br
he disk br he disk br he disk brak
ak
ak ak ake:
e:
e: e: e:
z
Press lever (1) with net tensioning bar approx. 10°
against spring tension
z In this position, the net roller must be just free (turns
sluggishly); the default basic position depends on
the diameter of the net roller!
RRRRRe-adjus e-adjus
e-adjus e-adjus e-adjustment
tment
tment tment tment:::::
z Fine adjustment using screw/locknut M8 (4)
z Then tighten screw/locknut (4) again
z When the net tensioning bar vibrates too much,
adjust the sliding ledges (5) closer for optimum
attenuation when the net is running.
5
stop go
+/-
1
4