DEUTZ-FAHR MP135 R, Operation Manual

Page: 25 / 62

23
EN
16652807_en 05/2006
When the machine is disconnected, the "Autoform" can
remain in the tractor cab. The cable plug (bolt
connection) is to be separated at the box housing.
If not in use the control box can be attached to a special
support on the left hand drawbar side, next to the front
panel.
Note:
The "Autoform" must be protected against
damp!
4.3 Adapting the drawbar
The drawbar is to be adjusted in such a way that the
baler is horizontal when hooked up, when the vehicle
is equipped with standard tyres. When the vehicle is
equipped with 500-tyres, the baler must be slanting
approx. 2° to the front to achieve optimum material
flow. The drawbar height is set by loosening the
fastening bolt and adjusting the toothed disks. A hitching
height of a minimum of 193 mm and a maximum of
1159 mm is possible.
Warning !
When adjusting the drawbar, prevent the
baler from rolling away by placing chocks
in front of it.
A A A A Adjus djus djus djus djusting: ting: ting: ting: ting:
z
Bring the round baler into horizontal position using
the support wheel - adjustable crank. Orientate
towards the protective cover.
z Loosen the right and left drawbar fastening bolts
(on the device) and tilt the drawbar to hitch height
(centre of the ring-hitch fastening bolt to centre of
drawbar coupling/upper edge of pending
attachment)
z The ring hitch is to be brought into horizontal
position by loosening the ring-hitch fastening bolt.
z Ensure that the three fastening bolts are tight
= 1000 Nm (see Appendix A.1 for torque moment
of bolt connections)
1159
1059
962
862
772
672
594
494
432
332
293
193
0
1159
1059
962
862
772
672
594
494
432
332
293
193