Programming Domestic Telephone Numbers
If your system has been set-up for domestic dialling, this function allows any Master Code
holder to program telephone numbers that the control panel will call in the event of an alarm.
How To Program Telephone Numbers
1.
Enter your Master Code followed by 2 and the # button (eg. 2580 + 2#).
Three beeps will be heard and the STAY and AWAY indicators will begin to flash.
If there are telephone numbers already programmed, they will be displayed one digit
at a time via the Keypad indicators.
If there are no telephone numbers programmed, a further two beeps will be heard after
entering this mode. These two beeps are normally heard after the last digit of the last
telephone number has been displayed.
2.
Enter all digits for the first telephone number (eg. 611931).
You will notice that as each digit is entered, the corresponding Keypad indicators will
display.
3.
If there is more than one telephone number to be programmed, press *4. This will
insert a break between the first telephone number and the second telephone number.
If there is only one telephone number to be programmed, press the # button to exit this
function.
4.
Enter all the digits of the second telephone number (eg. 611931).
You will notice that as each digit is entered, the corresponding Keypad indicators will
display.
5.
After the last digit of the second telephone number has been programmed, press the #
button to exit this function unless a third telephone number is required. If there is a
third telephone number to be programmed, press the *4 button to insert a break
between the second telephone number and the third telephone number.
Disable Domestic Dialling
If at any time you wish to cancel domestic dialling (eg. You are moving house and do not
wish the system to continue calling your mobile phone etc), you may enter the following
sequence.
1.
Enter you Master Code followed by 2 and the # button (eg. 2580 + 2#).
Two beeps will be heard and the STAY and AWAY indicators will begin to flash.
2.
Press the * button followed by 4 and the # button (eg. *4#).
The STAY and AWAY indicators will now extinguish.
28
Solution
Ultima Operators Manual
Operators Manual UK
Detection Systems
