Unsetting the System
When you enter the premises after the system has been Set in AWAY Mode, or if you have
Set the system in STAY Mode 1 or STAY Mode 2, you will need to Unset the system to
disable detection devices that will activate an alarm.
If there has been an alarm condition prior to Unsetting the system, a flashing zone indicator
will be displayed, indicating a previous alarm on that zone.
How To Unset The System
1.
Enter your user code followed by the # button (eg. 2580#).
Two beeps will be heard.
Adding User Codes
Only the Master Code holder can add or change other system user codes including the
Master Code itself. Up to eight user codes may be programmed to operate the system.
How To Add A User Code
1.
Enter your Master Code followed by 1 and the # button (eg. 2580 + 1#).
Three beeps will be heard and the STAY and AWAY indicators will begin to flash.
2.
Enter the user code number (1 – 8) that you wish to add or change followed by the #
button (eg. 2# = User 2 / 8# = User 8 etc). Two beeps will be heard and the user
number that you just selected will now display on the Keypad indicators.
3.
Enter the digits required for the new code followed by the # button (eg. If you wish the
user code to be 5768, you would enter 5768#). Two beeps will be heard and the
STAY and AWAY indicators will extinguish.
If you wish to add or change any further user codes, repeat this procedure as many
times as required.
Adding Radio Remote User Codes
Only the Master Code holder can add or change other system user codes. Up to eight radio
remote user codes (User Codes 9 – 16) may be programmed to operate the system.
How To Add A Radio Remote User Code
1.
Enter your Master Code followed by 1 and the # button (eg. 2580 + 1#).
Three beeps will be heard and the STAY and AWAY indicators will begin to flash.
2.
Enter the radio remote user code number (9 – 16) that you wish to add followed by the
# button (eg. 9# = User 9 / 16# = User 16 etc). Two beeps will be heard and the user
number that you just selected will now display on the Keypad indicators.
3.
Enter the 9 digit ID number found on the back of the radio remote hand held
transmitter followed by the # button. Two beeps will be heard and the STAY and
AWAY indicators will extinguish.
If you wish to add or change any further radio remote user codes, repeat this procedure
as many times as required.
14
Solution
Ultima Operators Manual
Operators Manual UK
Detection Systems
