Zone
Indicator
Fault
Description
Hold Down
Button
Zone
Indicator
Fault
Condition
1
System Fault
1
1
Battery Fail
2
Date & Time
3
RF Receiver Fail
4
Horn Speaker Fail
5
Telephone Line Fail
6
E2 Fault
7
Fuse Fail
8
AC Fail
2
RF Low Battery
2
1 - 8
Zones 1 - 8 RF Low Battery
3
Zone Tamper Alarm
3
1 - 8
Zones 1 - 8 Tamper Alarm
4
Sensor Watch Fault
4
1 - 8
Zones 1 – 8 Sensor Watch
Fail
5
RF Sensor Watch
5
1 – 8
Zones 1 - 8 RF Sensor Watch
Fail
6
Communication Fail
6
1
Receiver 1 Fail
2
Receiver 2 Fail
Table 7: Fault Indicators
Fault Descriptions
System Fault
A system fault will only display when any of the following faults occur. After entering fault
analysis mode, press and hold button 1 will determine which of the following faults have
occurred.
Low Battery
A low battery fault will register when the system detects a low capacity back-up battery.
The system automatically performs a battery test every 4 hours and also every time you Set
the system.
Date and Time
The date and time fault will register every time the system has been powered down. This
type of fault will not cause the FAULT indicator to display on the Keypad unless your
Engineer has programmed the automatic setting time. Refer to page 20 to program the date
and time.
1
Solution
Ultima Operators Manual
19
Detection Systems
Operators Manual UK
