Omitting Zones
Omitting zones allow you to manually disable one or more zones before setting the system.
Once a zone has been omitted, access is allowed into that zone during the Set state without
activating an alarm.
An example when you may require to omit a zone before setting the system could be when a
PIR detector may be false alarming or that you may need to leave a pet inside a particular
zone whilst you are away.
Omitting zones is performed by one of two methods. Method two is optional and only
allows those user codes programmed by your Engineer to have access to omit zones.
Standard Omitting
Standard Omitting allows all operators to be able to omit zones without the need to know a
valid user code.
How To Omit A Zone
1.
Press the * button twice to enter the omitting mode.
Three beeps will be heard and the STAY indicator will flash.
2.
Enter the zone number (1 – 8) that you wish to select to omit followed by the * button.
(eg. 1* = Zone 1, 2* = Zone 2 etc).
As you select each zone to be omitted, you will notice that the corresponding zone
indicator will begin to flash. If you selected an incorrect zone to be omitted, enter the
incorrect zone number again followed by the * button.
Repeat Step 2 if more than one zone is required to be omitted until all zone that are
required to be omitted have been selected.
3.
Press the # button after you have selected all zones to be omitted.
Two beeps will be heard and the system will return to the Unset state.
Solution
Ultima Operators Manual
17
Detection Systems
Operators Manual UK
