FAULT Indicator
The FAULT indicator is used to display that the system has detected a system fault. Refer to
Fault Analysis Mode on page 17 for additional information on system faults.
Every time a new system fault has been detected (eg. FAULT indicator flashing), the
Keypad will begin to beep once every minute. Pressing the # button once will cancel the
once a minute beep and acknowledge the fault (eg. FAULT indicator on steady).
FAULT Indicator
Definition
On
There Is A System Fault That Needs To Be Rectified
Off
The System Is Normal, There Are No Faults
Flashing
There Is A System Fault That Needs To Be Acknowledged
Table 5: FAULT Indicator
Audible Indications
In general, the audible indicators given out by the Keypad buzzer are as follows:
Audible Indicator
Definition
Once Short Beep
A Button Has Been Pressed On The Keypad, Or, End Of Exit
Time When Set In STAY Mode 1 Or STAY Mode 2
Two Short Beeps
The System Has Accepted Your Code
Three Short Beeps
The Requested Function Has Been Executed
One Long Beep
Indicates the End Of Exit Time When Set In AWAY Mode,
Or The Requested Operation Has Been Denied Or Aborted
One Beep Every Second
Walk Test Mode Is Currently Active Or Warning Before
Automatic Setting Takes Place
One Short Beep Every
Minute
There Is A System Fault Waiting To Be Acknowledged
Table 6: Audible Indicators
10
Solution
Ultima Operators Manual
Operators Manual UK
Detection Systems
