Day Alarm
Day alarm allows a combination of zones to be monitored during the Unset state by beeping
the Keypad buzzer. Only your Engineer can program zones 1 – 4 to operate for day alarm.
Example
An example set-up of a day alarm could be the front door of a shop that has a pressure mat or
electronic beam that customers activate as they enter to and from the shop. As the customers
walk onto the pressure mat or break the electronic beam, the Keypad buzzer will beep.
How To Turn Day Alarm On
1.
Hold down button 4 until three beeps are heard.
Day alarm will now be turned on. All zones programmed for day alarm operation will
cause the Keypad buzzer to beep during the Unset state when activated.
How To Turn Day Alarm Off
1.
Hold down button 4 until two beeps are heard.
Day alarm will now be turned off.
Keypad Buzzer Tone Change
Holding down button 8 continuously will change the tone of the Keypad buzzer. There are
fifty different tones to choose from between 1500 Hz – 5000 Hz. If multiple Keypads have
been installed, each Keypad can have a different tone.
Remote Setting Via Telephone
This feature allows you to Set your system from any remote location via the telephone. For
obvious security reasons, the system cannot be Unset using this method. To make use of this
feature, you will require a touch-tone telephone. Your Engineer needs to program this
feature to operate.
How To Remotely Set Your System Via The Telephone
1.
Call the telephone number that your control panel is connected to.
2.
When the control panel answers the incoming call, a short jingle will be heard. Press
the * button on the touch-tone telephone for 1 - 3 seconds to Set the system.
If you hear modem tones when the control panel answers the incoming call, this
means that the system has been programmed for remote programming functions by
your Engineer. Simply wait for a pause between the tones before pressing the *
button.
After releasing the * button on the touch-tone telephone, two beeps will be heard to
indicate that the system has been Set in AWAY Mode.
3.
Hang up the telephone and the system will remain Set.
Note:
If your Engineer has programmed answering machine bypass, you will need to call
the control panel twice to make a connection with the system (eg. Call the telephone
number that your control panel is connected to and let the call ring no more than 4
rings and then hang up the telephone. Wait a minimum of 8 seconds before you call
the control panel back again).
Solution
Ultima Operators Manual
25
Detection Systems
Operators Manual UK
