Areas
This feature is only applicable to the Solution Ultima control panel. Your control panel can
be partitioned or split into two individual areas. Both areas can be operated from one
“Master Area” Keypad, or from two separate “Area Addressable” Keypads.
Master Area Keypad Indicators
The indicators on a “Master Area” Keypad are configured into four groups
(i.e. Zone Indicators, Area On/Off Display, Area Display and Status
Indicators). Refer to “Figure 5: Master Area Keypad”. The following is a
description of what the indicators mean.
Zone Indicators
Zone indicators 1 – 8 show the status of each zone. These zones belong to
the area that has the “AREA DISPLAY” indicator displayed (i.e. If an
indicator is displayed, that zone is Open and if the indicator is not displayed,
that zone is Closed).
Area ON/OFF Indicators
The group of four “AREA ON/OFF” indicators display the status of each area (i.e. If an
indicator is displayed, that area is Set and if the indicator is not displayed, that area is Unset).
Note that only Area 1 and Area 2 can be used with the Solution Ultima control panel.
Area Display Indicators
The group of four “AREA DISPLAY” indicators show which area that the zones displayed
belong to.
Status Indicators
A group of four indicators display the following:
AUX Indicator
The AUX indicator displays when the control panel is using the telephone line
communicating to the receiving party.
MAINS Indicator
The MAINS indicator displays the status of the AC mains power (i.e. If the indicator is
illuminated, the AC mains power supply is normal. If the indicator is flashing, the AC mains
power supply has been disconnected or has failed).
FAULT Indicator
The FAULT indicator displays the status of the fault register (i.e. If the FAULT indicator is
flashing, the system has detected a fault that has not yet been acknowledged. If the FAULT
indicator is illuminated, the fault has been acknowledged. If the FAULT indicator is not
illuminated, the system has no faults).
PARTIAL Indicator
The PARTIAL indicator only displays when an area has been Set in STAY Mode 1 (i.e. If
the PARTIAL indicator is displayed, an area has been Set in STAY Mode 1. If the
PARTIAL indicator is not displayed, no areas have been Set in STAY Mode 1).
Figure 4: Master Area Keypad
26
Solution
Ultima Operators Manual
Operators Manual UK
Detection Systems
