90
7
Enter the setting.
The Channel Level screen reappears.
NOTES:
• When adjusting the level of an active subwoofer system, you may also need to adjust the subwoofer’s own volume control.
• When you adjust the channel levels while in the SYSTEM SETUP CHANNEL LEVEL mode, the channel level adjustments made will affect
all surround modes for ZONE2.
• After you have completed the SYSTEM SETUP CHANNEL LEVEL adjustments, you can then activate the individual surround modes and
adjust channel levels that will be remembered for each of those modes. Then, whenever you activate a particular surround sound mode,
your preferred channel level adjustments for just that mode will be recalled. Check the instructions for adjusting channel levels within
each surround mode. (See pages 173, 174)
• You can adjust the channel levels for each of the following surround modes for ZONE2: STEREO, DOLBY/DTS SURROUND, 5/7 CH
STEREO, WIDE SCREEN, SUPER STADIUM, ROCK ARENA, JAZZ CLUB, CLASSIC CONCERT, MONO MOVIE, VIDEO GAME, MATRIX
and VIRTUAL.
6
a. When “Auto” mode is selected:
Test tones are automatically emitted from each speaker used in
ZONE2.
The test tones are emitted from each speaker in the following order,
at 4-second intervals the first time and second time around, 2-
second intervals the third time around and on:
Use the cursor left and right buttons to adjust all the speakers to the
same volume.
The volume can be adjusted between –12 dB and +12 dB in units of 0.5
dB.
b. When “Manual” mode is selected:
Example: When the volume is set to –11.5 dB
while the test tone is being
produced from the Front Lch
speaker
FL
C
FR
SR
SL
SW
F L : - 1 1 . 5 d B
Z 2 T e s t T o n e A
q
Select the speaker used in ZONE2.
w
Adjust all the speakers to the same
volume.
Example: “Manual” mode is selected.
F L : - 1 1 . 5 d B
Z 2 T e s t T o n e M
(Main unit)
(Remote control unit)
(Main unit)
(Remote control unit)
(Main unit)
(Remote control unit)
(Main unit)
(Remote control unit)
To cancel the settings, press the cursor down button to select “Level Clear” and “Yes” on the
“Channel Level” screen, then make the settings again.
Flashing
Flashing