1
133
After starting playback
[3] Turning the sound off temporarily (MUTING)
1
Use this to mute the audio output temporarily.
Press the MUTE button.
Muting level is the same level as set with “7-3.
Volume Control” (See page 105).
Cancelling MUTING mode.
Press the MUTING button again, or press the volume up or down
buttons on the Remote control, or adjust the volume up or down via the
front panel volume control knob.
1
[2] Listening over headphone
1
Plug the headphone’ plug into the jack.
Connect the headphone to the PHONES jack.
The pre-out output (including the speaker output)
is automatically turned off when headphones are
connected.
1
PHONES
(Remote control unit)
NOTE:
• To prevent hearing loss, be careful not to raise the volume level
excessively when using headphones.
[1] Setting the Room EQ
1
The Room EQ switches as follows each time the ROOM EQ button is
pressed.
(Main unit)
(Remote control unit)
OFF
Audyssey
Front
Flat
Manual
See page 43 for descriptions of the correction curves for the “Room
EQ” function.
When “Audyssey” is selected, the MultEQ XT indicator lights green. If
“Front” or “Flat” is selected, the MultEQ XT indicator lights red.
The MultEQ XT indicator also lights red if the “Speaker Configuration”,
“Delay Time”, “Channel Level” or “Crossover Frequency” is set
manually after conducting the Auto Setup procedure.
1
1
[4] Combining the currently playing sound with the desired image (VIDEO SELECT)
1
Press the Remote control unit or Main unit’s VIDEO SELECT button until
the desired image appears.
The video source selected with the video select function is stored in the
memory for the different input sources.
Cancelling simulcast playback.
• Select “SOURCE” using the VIDEO SELECT button.
1
(Main unit)
V I D E O S O U R C E
D V D
1
(Remote control unit)
