• EXT. IN-1
Once this is selected, the input signals connected to the FRONT-L,
FRONT-R, CENTER, SURR.-L A/B (surround left A/B), SURR.-R A/B
(surround right A/B) SB-L (surround back left) and SB-R (surround back
right) channels of the EXT. IN jacks are output directly to the front (left
and right), center, surround A/B (left and right A/B) and surround back (left
and right) speaker systems as well as the pre-out jacks.
In addition, the signal input to the SW (subwoofer) jack is output to the
PRE OUT SW (subwoofer) jack.
• EXT. IN-2
Once this is selected, the input signals connected to the FRONT-L, FRONT-R, CENTER,
SURR.-L (surround left) and SURR.-R (surround right) channels of the EXT. IN jacks are
output directly to the front (left and right), center and surround (left and right) speaker
systems as well as the pre-out jacks.
In addition, the signal input to the SW (subwoofer) jack is output to the PRE OUT SW
(subwoofer) jack.
Playback using the external input jacks (EXT.IN-1 and EXT.IN-2)
q
When the “ANALOG” mode is selected at “3-2. EXT.IN Setup” at the System Setup:
The surround playback mode button does not function.
w
When the “DSP” mode is selected at “3-2. EXT.IN Setup” at the System Setup: The
surround playback mode button functions.
Press the SURROUND PARAMETER button to display the surround parameters screen.
Select the parameter (Cursor up/down) and select the setting value (Cursor left/right).
Press the SURROUND PARAMETER button to complete.
• Input CH parameter
2 CH:
Select when the input source being played is a 2-channel source.
MULTI CH: Select when the input source being played is a multi-channel source.
131
Playback using the external input (EXT. IN) jacks
1
Set the external input (EXT. IN) mode.
Press the EXT. IN button on the main unit or INPUT
MODE button on the remote control unit to switch
the external input.
The playback switches as shown below
each time the button is pressed.
2
Cancelling the external input mode
To cancel the external input (EXT. IN) setting, press the INPUT MODE or ANALOG button on the
main unit or INPUT MODE button on the remote control unit to switch to the desired input
mode.
1
2
1, 2
EXT. IN-2
EXT. IN-1
(Main unit)
(Main unit)
(Remote control unit)
• When the input mode is set to EXT. IN (1 or 2), playback in the DIRECT, STEREO, DOLBY/DTS SURROUND, HOME THX CINEMA, WIDE
SCREEN, 9CH STEREO and DSP SIMULATION modes is only possible when DSP MODE is selected for EXT.IN Setup at System Setup.
• When the DIRECT button is pressed while the input channel parameter is set to “MULTI CH”, the MULTI CH DIRECT mode is set. When the
STANDARD button is pressed, the MULTI CH IN mode is set. (See page 193)
• To lower the subwoofer channel level in the EXT. IN mode, press SURROUND PARAMETER and select “SW. ATT”.
For some players the playback level of the SW channel may seen strong. If so, set to “ON”.
NOTES:
• In play modes other than the external input mode, the signals connected to these jacks cannot be played. In addition, signals cannot be
output from channels not connected to the input jacks.
• The external input mode can be set for any input source. To watch video while listening to sound, select the input source to which the
video signal is connected, then set this mode.