Dell PowerConnect J-EX4200, Hardware Manual

Page: 147 / 238

}
ethernet-switching-options {
storm-control {
interface all;
}
}
poe {
interface all;
}
Related
Documentation
Connecting and Configuring a J-EX Series Switch (CLI Procedure) on page 131
•
•
Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 133
•
For information about J-EX Series switch configuration files and interfaces and
instructions for reverting to the factory default configuration, see the
Dell PowerConnect
J-Series Ethernet Switch Complete Software Guide for Junos OS at
http://www.support.dell.com/manuals
.
Connecting and Configuring a J-EX Series Switch (CLI Procedure)
There are two ways to connect and configure a J-EX Series switch: one method is through
the console using the CLI and the other is using the J-Web interface. This topic describes
the CLI procedure.
NOTE: To run the
ezsetup
script, the switch must have the factory default
configuration as the active configuration. If you have configured anything on
the switch and want to run
ezsetup , revert to the factory default configuration.
For instructions, see the Dell PowerConnect J-Series Ethernet Switch Complete
Software Guide for Junos OS at
http://www.support.dell.com/manuals
.
Before you begin connecting and configuring a J-EX Series switch through the console
using the CLI:
•
Set the following parameter values in the console server or PC:
•
Baud Rate—9600
• Flow Control—None
•
Data—8
•
Parity—None
131
Chapter 12: Performing Initial Configuration