Dell PowerConnect J-EX4200, Hardware Manual

Page: 107 / 238

•
In a position recessed 2 in. from the front of a 19-in. rack or cabinet by using the
2-in.-recess front brackets in the separately orderable four-post rack-mount kit. You
can mount the switch in this recessed position on two-post or four-post racks and
cabinets.
•
On a desk or other level surface by using rubber feet. The switch is shipped with four
rubber feet to be used to stabilize the chassis on a desk or other level surface.
• On a wall by using the separately orderable wall-mount kit.
The holes in the mounting brackets are placed at 1 U (1.75 in. or 4.45 cm.) apart so that
the switch can be mounted in any rack or cabinet that provides holes spaced at that
distance.
Related
Documentation
Mounting a J-EX4200 Switch on Two Posts in a Rack or Cabinet on page 92
•
•
Mounting a J-EX4200 Switch on Four Posts in a Rack or Cabinet on page 96
•
Mounting a J-EX4200 Switch in a Recessed Position in a Rack or Cabinet on page 100
•
Mounting a J-EX4200 Switch on a Desk or Other Level Surface on page 91
•
Mounting a J-EX4200 Switch on a Wall on page 100
•
Connecting Earth Ground to a J-EX Series Switch on page 115
Mounting a J-EX4200 Switch on a Desk or Other Level Surface
You can mount a J-EX4200 switch on a desk or other level surface by using the 4 rubber
feet that are shipped with the switch. The rubber feet stabilize the chassis.
Before mounting a J-EX4200 switch on a desk or other level surface:
• Verify that the site meets the requirements described in “Site Preparation Checklist
for J-EX4200 Switches” on page 57.
•
Place the desk in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
• Read “General Safety Guidelines and Warnings for J-EX Series Switches” on page 171,
with particular attention to “Chassis Lifting Guidelines for J-EX4200 Switches” on
page 184.
• Remove the switch from the shipping carton (see “Unpacking a J-EX4200 Switch” on
page 88).
Ensure that you have the following parts and tools available:
• 4 rubber feet to stabilize the chassis on the a desk or other level surface (provided in
the accessory box shipped with the switch)
•
Dust covers for ports (for J-EX4200-24F switches only; optional)
To mount the switch on a desk or other level surface:
91
Chapter 9: Installing the Switch