Dell PowerConnect J-EX4200, Hardware Manual

Page: 143 / 238

CHAPTER 12
Performing Initial Configuration
• J-EX4200 Default Configuration on page 127
• Connecting and Configuring a J-EX Series Switch (CLI Procedure) on page 131
•
Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 133
•
Setting the Mode on an SFP+ Uplink Module (CLI Procedure) on page 135
J-EX4200 Default Configuration
Each J-EX Series switch is programmed with a factory default configuration that contains
the values set for each configuration parameter when a switch is shipped. The default
configuration file sets values for system parameters such as
syslog and commit ; configures
Power over Ethernet (PoE), storm control, and Ethernet switching on all interfaces; and
enables the LLDP and RSTP protocols.
When you commit changes to the configuration, a new configuration file is created that
becomes the active configuration. You can always revert to the factory default
configuration. For instructions, see the
Dell PowerConnect J-Series Ethernet Switch
Complete Software Guide for Junos OS at http://www.support.dell.com/manuals .
The following factory default configuration file is for a J-EX4200 switch with 24 ports
(for models that have more ports, this default configuration file has more interfaces):
NOTE: In this example,
ge-0/0/0
through
ge-0/0/23
are the network interface
ports. Optional uplink modules provide four 1-gigabit SFP transceivers
(
ge-0/1/0 through ge-0/1/3 ). Although you can install only one uplink module,
the interfaces for both are shown below.
system {
syslog {
user * {
any emergency;
}
file messages {
any notice;
authorization info;
}
file interactive-commands {
127