LS10 Installation and Operating Guide
Page 79
LS10 Installation & Operating Guide
Document # 9301H66300 Ver. 1.01
There is one configuration for each of the channel pairs, and a separate configuration for the Center, High
Center, and Top channels. Individual configurations can be made for the following speakers or speaker
pairs:
•
Center Speaker (C)
•
High
Center
(HC)
•
Top
(T)
•
Left Front, Right Front (L/R)
•
Left Surround and Right Surround (Ls/Rs)
•
Left Back Surround and Right Back Surround (Lb/Rb)
•
Left High Front and Right High Front (Lh/Rh)
•
Left Wide Front and Right Wide Front (Lw/Rw)
•
High Left Surround and High Right Surround (HLs/HRs)
The speakers that can be selected for bass management crossover options depends on the speaker
configuration.
4.1.2 Single Subwoofer
A bass management configuration with a single subwoofer will mix the low frequency of all crossover
channels with the LFE channel. You can select which speakers to cross by assigning them to be “small”
speakers in the bass management configuration setup screens.
4.1.3 Two Subwoofers
When there are two subwoofer channels assigned using bass management the LFE channel is evenly
mixed between both of the subwoofers. The LFE in SUB 1 and SUB 2 is attenuated to compensate for
having two subwoofers. The summed output level can be adjusted for each subwoofer on the Audio
Levels screen.
When two subwoofer channels are used they can be assigned location information to specify Left/Right,
Front/Back, or 2 X Mono positioning. If Left/Right is selected, the speakers on the left will be crossed with
the left subwoofer (SUB 1) while speakers on the right are crossed with the right subwoofer (SUB 1). The
Center, High Center and Top speakers would always be crossed evenly between both subwoofers.
If Front/Back is selected, the front speakers are crossed with front subwoofer (SUB1) while surrounds are
crossed with back subwoofer (SUB 2).
The option 2 X Mono can be used if it is preferred to have both subwoofer outputs be the same. That is,
an equal mix of crossed signals from all speakers.
4.1.4 No Subwoofers
When no subwoofer is installed, the LFE can be mixed with the Left/Right and/or Left Surround/Right
Surround speakers by having those speakers selected as “Large” in the Speaker Options screen.
Figure 60 illustrates the LFE input being mixed with the left channel.
