LS10 Installation and Operating Guide
Page 57
LS10 Installation & Operating Guide
Document # 9301H66300 Ver. 1.01
Subwoofer Configuration
Options
Number of
Subwoofers
Subwoofer Assignments
No Subs
0 None
Mono
1
SUB 1 Mono
2 x Mono
2
SUB 1 Mono, SUB 2 Mono
Left/Right
2
SUB 1 – Left, SUB 2 - Right
Front/Back
2
SUB 1 – Front, SUB 2 - Back
4. Select
Full Range to Subs
only if you wish to omit the Low Pass filter for all channels crossed to the
subwoofer.
Speaker configurations
For steps 5 through 13, tap on the speaker below its label and set the options for that speaker. Skip
any speakers that do not apply to the current speaker configuration. Use the Back button to return to
the main Bass Management screen to select the next speaker. Those speakers that are not used will
be grayed out and cannot be selected.
5.
C – Center
speaker options:
a.
Large
– (default) Speaker can handle full range of frequencies.
b.
Small
– Cross with the subwoofer(s). Select the desired crossover filter frequency and slope.
The high-pass filter to the Center speaker may be disabled if desired.
c.
Low Pass to Left/Right
– Cross the center channel to the Left and Right Front speakers.
Adjust the crossover frequency and slope as needed.
d.
Phantom Center
– Use this if there is no center speaker installed. This divides the center
channel between the left and right speakers. The offset can be adjusted. Note: when this is
selected, the speaker is grayed out on the main Bass Management screen.
6.
L, R – Left
and
Right
speaker options:
a.
Large
– (default) Speaker can handle full range of frequencies.
b.
Small
– Cross with the subwoofer(s). Select the desired crossover filter frequency and slope.
The high-pass filter to the Left and Right speaker may be disabled if desired.
7.
Ls, Rs – Left Surround
and
Right Surround
speaker options:
a.
Large
– (default) Speaker can handle full range of frequencies.
b.
Small
– Cross with the subwoofer(s). Select the desired crossover filter frequency and slope.
