LS10 Installation and Operating Guide
Page 72
LS10 Installation & Operating Guide
Document # 9301H66300 Ver. 1.01
3.19 Access Control
Press the
Access
button on the
Setup Home
screen to open the
Setup Access Control
screen.
By creating passwords, you can control user access to certain functions of the LS10.
Figure 52. Access Control
Note
: This application accepts only Latin alphanumeric characters.
Enter your
Network Command
password and
Setup
Password, to continue.
The
NetCmd
password is used to prevent unauthorized access to network TCP/IP operator level
commands. A
Setup
password is used to authorize a network TCP/IP connection to perform setup
commands, and also sets the password for VNC access.
If the setup password is set to “-“ then the password is disabled at the LS10 touchscreen, but VNC
access will require the “-“ as a password for access. If this is set to blank, the password will be disabled
for both the touchscreen and VNC access.
Note
: Remember that the setup password entered must be used to reenter the VNC
interface.
If the password is lost and you cannot access the LS10, contact Datasat Digital Entertainment technical
support.
Password restrictions take place as soon as the password is configured in the Access Control screen.
Passwords are case sensitive. You can enter upper case characters by using the shift button on the
virtual keyboard (see figure below). To remove Setup password protection, clear the password by
pressing the
Clear
button, then enter a hyphen “-“ and press
OK
.
Tap
Home
to return to the
Setup Home
screen.
