Datalogic DM3610, Reference Manual, Page: 61 / 157

DC3000 USER INTERFACE
51
4
4 DC3000 USER INTERFACE
4.1 GETTING STARTED
The Two-Head Dimensioning System uses a familiar browser-based user interface, which is
based on the DM3610 Dimensioner application
and resides on the system’s DC3000
Controller. It is the tool you will use to define operating parameters, monitor dimension
quality, construct output messages, and view diagnostics for the system. The User Interface
enables you to configure, fine-tune, and monitor your dimensioning system operations.
CAUTION:
Because the DC3000 Controller user interface and that of the
individual dimensioners look similar, make sure you are using the DC3000
Controller’s user interface to configure the two-head dimensioning system.
4.1.1 Prerequisites
Before setting up your multi-head dimensioning system you will need the following:
Computer Laptop
Browser Internet Explorer 8 (or later)
NOTE : Internet Explorer 10 (or later) is required
to view Diagnostics | DimView and Diagnostics
| Monitor .
Firefox 18.0 (or later)
Chrome 24.0.1312 (or later)
Java Version 7, Update 9 (or later)
4.1.2 Accessing the DC3000 User Interface
To access the DC3000 User Interface:
1. Connect your laptop computer to the master DM3610 (HEAD1) HOST port using
either the CAB-ETH-M0x M12-IP67 ETHERNET CABLE or CBL-1534-0.2
ADAPT.CABLE ETH M12-TO-RJ45F.
2. Turn on your laptop computer.
3. Y
ou must configure your PC’s IP Address to be in the same network as the DC3000’s
IP Address.
NOTE
: The same changes to the laptop PC’s IP address
described below will be used when accessing the DM3610
User Interface.