Datalogic DM3610, Reference Manual, Page: 51 / 157

ELECTRICAL INSTALLATION
41
3
3.6 CBX510 CONNECTION BOX
Complete installation information for the connection box is available in the
CBX510
Installation Manual available at www.datalogic.com . A simple drawing of the interior of the
box is shown below.
Figure 37: CBX510 Interior
3.7 CONNECTING A PC TO THE MASTER DM3610
During initial setup, a PC (laptop) may be connected to the Master DM3610 (HEAD1) with an
M12 to RJ45 cable. Screw the M12 connector to the HOST port of HEAD1 and plug the RJ45
into the Ethernet port of your PC. For information on connecting to the User Interface,
see
chapter 4.
3.8 WIRING INTO THE CBX510 CONNECTION BOX
WARNING:
DO NOT connect a separate power source to the CBX510
connection box. The CBX510 receives its power through its connection to
the DM3610 Dimensioner (HEAD1). Connecting a separate power source
will be detrimental to the system operation.
Loose-lead cables must pass through the water-tight seals in the base of the CBX510
connection box. Insert the cables allowing enough slack for the individual wires to reach the
appropriate pin block connectors. Securely tighten the water-tight seals after the cables have
been inserted.
Insulation on individual wires should be removed to expose 13 mm [0.5 inch] of bare metal
before inserting into the pin block.